Either job was printed with settings changed or it was cancelled.”Īn error occurred during printing, but it was skipped. For details about setting "Apply 2 sided", see Tray Paper Settings. Ĭhange the setting for "Apply 2 sided" in to enable duplex printing for the paper tray. For details about paper size, see Supported Paper for Each Input Tray.
Select the proper paper size for the duplex function. If the message appear after installing the hard disk, contact your service representative. The hard disk is required when printing a Sample Print, Locked Print, Hold Print, or Stored Print. You tried to print a Sample Print, Locked Print, Hold Print, or Stored Print file while the hard disk was not installed. The printer detected corrupt compressed data.Ĭheck the connection between the computer and the printer.Ĭheck that the program you used to compress the data is functioning correctly. Ĭheck that the communication between a device and the printer is working correctly. For details about how to specify classification code settings, see Registering Classification Codes. Select Optional for the classification code.
The classification code is not supported by the printer driver. The classification code has not been entered, or the classification code has been entered incorrectly. “Auto-registration of user information has failed.”Īutomatic registration of information for LDAP Authentication or Windows Authentication failed because the Address Book is full.įor details about automatic registration of user information, see Security Guide. Wait a while, and then retry the operation. The printer currently cannot perform authentication because the Address Book is being used by another function. “Address Book is currently in use by another function. If the message appears frequently, contact your service representative. Turn the main power switch off and then back on again. The printer could not access the hard disk correctly. Perform the print operation again as necessary. Printing was canceled because or the key was selected on the printer's control panel. Printing was canceled by the auto job cancel function due to a command error. Parameters of the control code are invalid. The specified graphics library is unavailable.
For details about installing SDRAM module, see Installing the SDRAM module. ĭecrease the number of files sent to the printer or install the optional SDRAM module. There is no work area available for image processing. This section describes likely causes of and possible solutions for the error messages that are printed on the error logs or reports.
0 kommentar(er)
